Old craftsman table saw rip fence not square

Position the jaws of the pipe clamp downwards and slide the rear part of the clamp towards the table saw. The cranking end of the pipe clamp should be facing towards you. Once the rip fence has been completed set it on top of the table saw. Fasten the pipe clamp end to this section of the pipe. Slide the pipe into one end of the square tube and through the other end. Take one end of the pipe clamp and thread it onto the 4 foot length of pipe. Repeat the process with the other end and the other square. Position it so that it is flush with the outside edge. Once the square tube is made, place one of the plywood squares in one end of the tube. Connect these pieces with the wood screws. Use the 4 inch wide strips as the sides and the 2 inch wide strips as the top and bottom. To make the rip fence body you will be making a square tube. Drill a hole in the center of each one of these plywood squares. Step 3 - Cut 2 SquaresДЄfter you have finished cutting the plywood strips, you need to cut out 2 squares that are 2 1/2 inch wide and 2 1/2 inch long.

Once you have the 4 pieces of plywood cut you can trim them to match the measurement of the table saw. You will also need 2, 2 inch wide strips of the plywood. Step 2 - Cut Plywood Strips for TubeДЇor this rip fence you will need to build a square tube that is made with have 2, 4 inch wide strip of plywood. Cleaning the contact surfaces is more important than this step.In order to build a rip fence for the table saw you will need to know the width of the table part of the saw.

Then tighten the screw handle down (after pushing on the T part) and see if it stays square.Д§- You can also change the tension in the flat spring underneath the fence to make it slide smooth.

Then, carefully making sure that the fence doesn't move out of square, tighten the bolts down. Clamp the T part so it stays snug to the rail. Line it up PERFECTLY along the miter slot, clamp the far end to the table in the perfect position. Use a straight edge that fits in the miter slot (I used my miter bar perpendicular to the table) to check for square all along the length.Д¦- If your fence isn't square after step 5, loosen the two bolts on top of the fence. Here is the tldr:ДЎ- To get this fence to tighten square, you need to push on both sides of the T parts before screwing down.Дў- Take the fence off, clean the rails, and all contacting surfaces on the fence (these are HDPE, I used 0000 steel wool for everything and some wd40 on the metal)ДЈ- Square the blade to the miter slot - if this isn't right, nothing else will be, either.Д¤- Check that your fence is actually straight with a straight edge.ДҐ- slide your fence up to the miter slot, push on the T parts and screw down. Using this advice, I was able to get it pretty square. I just asked almost the same question, got some great advice, look here No top-level wood ID, low effort, or price queries No memes, image macros, reaction gifs/videos, etc. Projects related to firearms, religion, or flags will be allowed but locked. Includes but not limited to religious and political topics. No reposts, rehosted, or freebooted content. go to for a detailed explanation of the rules.ДonвЂ™t be rude. Before posting, check that your content doesn't violate the rules below. r/woodworking is a forum that encourages the respectful exchange of woodworking knowledge and projects. It IS under reconstruction right now, so we apologize for broken links, etc. 'How do I start?') and links to many valuable resources. BEFORE ASKING A QUESTION, DID YOU READ OUR WIKI? Our Wiki includes answers to common questions (e.g.

Old craftsman table saw rip fence not square